Inflation tube connection diagram
Instructions For Use (when used as an Tire Inflator)
Figure 5
How to use the digital display table:
: Press once to turn on the LED display,
Afterward, every press on the R can switch the unit between kg / m2,
PSI, BAR, KPA
: Decrease tire pressure
: Increase tire pressure
NOTICE: When the number flashes 3 times on the LED Screen,
the tire pressure value will switch back to the current value of the machine in real-time
Note
：
Before using, please make sure that the battery has sufficient power.
When measuring tire pressure:
1, Make sure the hose is connected according to Figure 5 (above).
2, Pressing the " " key, the LED screen will immediately display the tire pressure.
Tire Inflator Mode
1. Put the machine switch in the middle position (Shut down mode).
2. According to the above picture, connect one end of the inflation tube to the machine
and one end to the tire.
3. Press the key, the LED screen will turn on, and the current tire pressure will
be displayed.
Continue to press the key to adjust the unit: kg / m2, PSI, BAR, KPA
4. Press the key or key to adjust the preset tire pressure.
(Suggestion: Summer: 2.3 kg / cm2; Winter: 2.5 kg / cm2)
LED flashes 3 times, the preset tire pressure value is saved
To start the air pump, push the "Power" switch. The pump will automatically stop
when it reaches the desired value you previously set.
This will also turn off the LED screen
Attention: Please do not operate the air pump more than 10 minutes continuously
to prevent overheating.
5
