Oregon Scientific RMS600, Руководство пользователя

Страница: 6 / 92

E
N
4
3. Insert the battery, matching the polarities (+ / -). See
FIG 3.
4. Press RESET after each battery change.
5. Close the battery door.
NOTE
Install battery in the remote sensor before the main
unit.
6. Initiate a sensor search on the main unit to start
receiving temperature / humidity data from the sensor.
7. Secure the sensor in the desired location using the wall
mount hole.
NOTE
Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.
MAIN UNIT SET UP
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG
2).
3. Press RESET after each battery change.
NOTE
Batteries should not be exposed to excessive heat such
as sunshine or fire.
LOCATION
MEANING
Clock / alarm area Main unit batteries low
Outdoor sensor area Sensor batteries low
DATA TRANSMISSION
To search for a sensor:
Press and hold + MODE .
The remote sensor reception icon will show the following
status:
ICON DESCRIPTION
Main unit is searching for sensor(s).
A channel has been found.
The sensor cannot be found.
TIP
The transmission range may vary depending on many
factors. You may need to experiment with various locations
to get the best results.
P/N: 086L005521-019 REV1
6/92