22
Hedge Trimmer Model HT275
Troubleshooting
Troubleshooting
Use this table to see possible solutions for possible problems with the hedge trimmer If these
suggestions do not solve the problem, see “Service and Support Information”
SYMPTOM
POSSIBLE CAUSE
RECOMMENDED ACTIONS
Motor does
not run or runs
intermittently
Battery discharged
Recharge. See “Charging the Battery Pack”.
Trigger lock-out not
pressed
Press the trigger lock-out before squeezing the
throttle trigger. See “Starting the Hedge Trimmer”.
Battery pack not fully
inserted
Press the battery pack into the battery port until it
clicks into place.
Battery contacts dirty
Remove the battery pack, remove debris from the
battery port, and then clean the contacts with a
clean, dry cloth.
Battery pack cold
Allow the battery pack to warm to the minimum
operating temperature of 32°F (0°C).
Motor runs, but
cutting blades do
not move
Object preventing
cutting blade movement
See “Correcting Blade Bind”.
Hedge trimmer
does not cut
properly
Resin buildup
preventing cutting blade
movement
See “Blade Care”.
Cutting blades are dull
Have the cutting blades professionally sharpened.
Battery pack does
not charge
Battery pack over/under
temperature protection
is activated
This may occur when the hedge trimmer is
run continuously or exposed to high ambient
temperatures. Allow the battery pack to reach the
acceptable temperature range before charging. See
“Charging the Battery Pack”.
Dirty or damaged
contacts on battery
pack or charger
Inspect the contacts on both the battery pack and
the charger. Clean as described in “Maintenance and
Cleaning”, then reinsert into the charger and make
sure it is fully seated.
Battery pack is at the
end of its life
All batteries have a limited life. If the battery pack
is more than two years old or has been recharged
frequently, it may be time to replace it. Replace
only with the battery pack specified for this hedge
trimmer.
Charger faulty
Have the function checked at an approved service
location.
Содержание HT275
Страница 2: ......
