4
GB
HOW TO READ
THE RF SIGNAL INDICATOR
The RF signal indicator shows the signal-receiving status of the
main unit. There are three possible forms:
The unit is in searching mode.
Transmission data are securely
registered.
No signals.
REMOTE SENSOR SCANNING
The unit can be set to automatically scan and display readings
from the remote sensors. When the remote-sensor mode is active,
the display will show the readings from one channel for about 4-
second and then proceed to the next channel display.
To activate the remote-sensor scanning mode:
◊
Press and hold CHANNEL for 2-seconds.
To deactivate the remote-sensor scanning mode:
◊
Press any button.
DISCONNECTED SIGNALS
If without obvious reasons the display for a particular channel
goes blank, press[IN/REMOTE] to enforce an immediate search.
If that fails, check:
1. The remote unit of that channel is still in place.
2. The batteries of both the remote unit and main unit. Replace
as necessary.
Note that when the temperature falls below freezing point,
the batteries of outdoor units will freeze, lowering their
voltage supply and the effective range.
3. The transmission is within range and path is clear of obstacles
and interference. Shorten the distance when necessary.
TRANSMISSION COLLISION
Signals from other household devices, such as door bells, home
security systems and entry controls, may interfere with those of
this product and cause temporarily reception failure. This is
normal and does not affect the general performance of the product.
The transmission and reception of readings will resume once the
interference recedes.
LOW BATTERY WARNING
When it is time to replace batteries, the respective low-battery
indicator will show up when the respective channel is selected.
The battery level of the main unit will be shown on the indoor
temperature when it is running low.
THE RESET BUTTON
To clear user-defined setting or if the unit is operating in an
unfavorable way or malfunctioning use a blunt stylus to hold
down the RESET button. All settings will return to the factory
set defaults.
TABLE STANDING OR WALL MOUNTING
Table-Standing :
Your unit comes with stand connector for connecting it to other
modular units.
Wall-mounting:
Connector:
Use wall-mount connector to align with other wall-mount bracket
if necessary.
STAND
CONNECTOR
Wall mount
bracket
Wall Mount
Bracket
Wall Mount
Connector
CONNECTOR
