EN
6
To fold out the stand:
To use the wall mount:
For best results:
•
Insert the batteries and select the unit, channel, and
radio signal format before you mount the sensor.
•
Place the sensor out of direct sunlight and moisture.
•
Do not place the sensor more than 70 metres
(230 feet) from the main (indoor) unit.
•
Position the sensor so that it faces the main (indoor)
unit, minimizing obstructions such as doors, walls,
and furniture.
•
Place the sensor in a location with a clear view to
the sky, away from metallic or electronic objects.
•
Position the sensor close to the main unit during cold
winter months as below-freezing temperatures may
affect battery performance and signal transmission.
The transmission range may vary and is subject
to the receiving range of the main unit.
You may need to experiment with various locations to
get the best results.
SENSOR DATA TRANSMISSION
Data is sent from the sensor(s) every 60 Seconds. The
reception icon shown in the Temperature / Humidity Area
indicates the status.
NOTE
SEARCH FOR SENSOR
To search for a T hermo / Hygro sensor, press
SELECT
to navigate to the Temperature / Humidity Area.
will
show next to the Area. Then, simultaneously press and
hold
MEMORY
and
CHANNEL
for 2 seconds.
To search for the UV sensor, press
SELECT
to navigate
to the UVI / Barometer Area.
will show next to the
Area. Then, press and hold
MEMORY
and
CHANNEL
for 2 seconds.
If the sensor is still not found, check the
batteries.
ICON
DESCRIPTION
Main unit is searching for
sensors.
At least 1 channel has been
found.
Sensor 1 is sending data. (The
number shows which sensor is
selected.)
The selected sensor cannot be
found. Search for the sensor or
check batteries.
--- shows in Temp /
Humidity Area
NOTE
CLOCK AND CALENDAR
This product tracks the time and date based on radio-
controlled signals from the RTGR368N remote sensor,
or manual settings that you enter.
RADIO-CONTROLLED CLOCK
The time and date are automatically updated by radio-
controlled clock signals from official time-keeping
organizations in Frankfurt (Germany) and Rugby
(England) unless you disable this feature. The signals
are collected by the remote sensor (RTGR368N)
whenever it is within 1500 km (932 miles) of a signal.
Initial reception takes 2-10 minutes, and is initiated when
you first set up the unit, and whenever you press
RESET
.
Once complete, the reception icon will stop blinking.
The
icon shown in the Clock Area indicates
2 factors:
•
Connection between the main unit and the sensor
that collects RF signals (
)
•
RF signal reception ( )
How these signals work together:
ICON
MEANING
The unit has contact with the
sensor and has synchronized
the time.
The unit has contact with the
sensor but the time has not
been synchronized.
The unit has lost contact with
the remote sensor but the time
is synchronized.
The unit has lost contact with
the remote sensor and the time
is not synchronized.
The unit cannot reach the
remote sensor.
To force a manual search for RF clock reception,
press and hold
SEARCH
on the sensor (RTGR368N)
for 2 seconds.
TURN RADIO-CONTROLLED CLOCK ON / OFF
If you wish to manually set the clock, you must first
disable the radio-controlled feature. To do this, navigate
to the Clock / Alarm Area. Then, press and hold
DOWN
on the main unit for 2 seconds. To enable it, navigate to
the Clock / Alarm Area, then press and hold
UP
for
2 seconds.
NOTE
BAR933HG Eng R10 OP
11/23/04, 4:29 PM
6
Black
