14
E
N
(23.48 to 31.01 inHg)
Power
Main unit :uses four (4) UM-3 or “AA”
1.5V batteries
Remote sensing unit :uses two (2) UM-3 or “AA”
1.5V batteries
Weight
Main unit :
10.6 oz (30 g)
(without battery)
Remote sensing unit : 2.8 oz (80 g)
(without battery)
Dimensions
Main unit
:7.68 x 4.13 x 3.03 inches
or 95 (L) x 105 (W) x 77 (T) mm
Remote sensing unit :4.13 x 2.76 x .83 inches
or 105 (L) x 70 (W) x 21 (T) mm
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientific.com) to learn more
about Oregon Scientific products. If you’re in the US and
would like to contact our Customer Care department di-
rectly, please visit:
http://www2.oregonscientific.com/service/default.asp
OR
Call 1-800-853-8883.
For international inquiries, please visit:
www2.oregonscientific.com/about/international.asp
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.Op-
eration is subject to the following two conditions: (1)This
device may not cause harmful interference, and (2)This
device must accept any interference received, including
interference that may cause undesired operation.
WARNING
Changes or modifications not expressly ap-
proved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accord-
ance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
BAR898HGA MANUAL en.indd 14
2007.4.23 10:25:07 AM
P/N: 086L002778-078 REV1
15/47
