EN
6
SET UNIT AND ALTITUDE
You can set the barometric unit of measurement (mb /
hPa or inHg) and altitude. Doing this allows the product
to take more accurate barometric measurements.
1. Press
PRESSURE
to select the unit of
measurement: mb / hPa or inHg.
2. Press and hold
PRESSURE
for 2 seconds.
3. Select the altitude (-100 to 2500 metres) in
increments of 10). Press or to change the
setting. Press
PRESSURE
to confirm.
WEATHER FORECAST
This product forecasts the next 12 to 24 hours of weather
within a 30-50 km (19-31 mile) radius with 70 to 75
percent accuracy. The weather forecast is always
displayed.
TEMPERATURE AND HUMIDITY
This product can display current, minimum, and maximum
temperatures and humidity percentage information
collected by the remote sensors and main (indoor) unit.
Outdoor data is collected and displayed every 40 seconds.
Indoor data is collected and displayed every 10 seconds.
SELECT TEMPERATURE UNIT
Slide the
°
C /
°
F
switch into the desired location. The
switch is located on the front button panel. The setting for
the main unit overrides the remote sensor setting.
SELECT CHANNEL NUMBER
Press
CHANNEL
to switch between sensors 1-3.
The icon shows the selected sensor.
To auto-scan between sensors, press and hold
CHANNEL
for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL
or
MEMORY
.
NOTE
If you use a sensor that collects only temperature
data, humidity will not be shown.
NOTE
For more information on the sensor see "Remote
Sensor THGR122NX" Section.
SWITCH CLOCK DISPLAY
Press
MODE
to toggle between Clock with Seconds and
Clock with Weekday display.
ALARM
This product is equipped with a 2-minute crescendo
alarm.
VIEW ALARM SETTINGS
Press . The alarm time and alarm status will show
in the Clock Area.
SET ALARM
1. Press to switch to alarm display.
2. Press and hold again for 2 seconds. The alarm
settings will blink.
3. Select the hour and minute. Press or to change
settings. Press to confirm.
ACTIVATE ALARM
Press to activate or deactivate the alarm. shows in
the Clock / Alarm Area when the alarm is activated.
SILENCE ALARM
When the alarm time is reached, the crescendo alarm
will sound for 2 minutes. To silence the alarm:
• Press
SNOOZE / LIGHT
to silence it for 8 minutes.
OR
• Press any key except
SNOOZE
to mute the alarm
and activate it again after 24 hours.
If no button is pressed, the alarm will automatically
silence after 2 minutes. It will then sound again after 8
minutes.
BAROMETER
This product tracks barometric pressure changes over
the past 24 hours to provide the weather forecast and a
trend line showing the direction of barometric change.
Barometric changes are measured by the main (indoor)
unit.
BAROMETRIC TREND
TREND
DESCRIPTION
Rising
Steady
Falling
SUNNY
PARTLY
CLOUDY
RAINY
CLOUDY
KINETIC-
WAVE
ICON
DESIG-
Indoor
Remote
Remote
Remote
NATED
Display
Display
Display
Display
DISPLAY
Channel 1 Channel 2 Channel 3
