5
EN
HOW TO SET THE CLOCK AND THE
CALENDAR
When you first start up your barometer (or after you
replace the batteries or reset the unit) use the following
steps to set your clock and calendar:
1. Press and hold the
[MODE]
button for about 2
seconds. The month digits will flash. Press the
[
]
button to increase the setting in 1 month increments
until the desired month is displayed.
2. Once the month is correct, press the
[MODE]
button
again to display the date digits. The date digits will be
flashing. Use the
[
]
button to increase the date in
1 day increments until the desired day is displayed.
3. Once the day is correct, press the
[MODE]
button.
You’ll see 12hr or 24 hr flashing. Pressing the
[
]
button will toggle between the 12 and 24 hour settings.
4. Once the clock format is correct, press the
[MODE]
button. The hour digits will be flashing. Press the
[
]
button again to increase the clock in 1 hour increments
until the desired hour is displayed.
5. Once the hour is correct, press the
[MODE]
button
again to create the flashing minute digits. Pressing
the
[
]
button will increase the minutes one at a
time, until the correct time is displayed.
6. Finally press the
[MODE]
button to confirm all the
settings you just entered. The unit will return to the
clock display.
HOW TO SET THE DAILY ALARM
Follow the
below
steps to set your daily alarm:
1. In a normal time display, press and hold the
[ALARM]
button for about 2 seconds. The
will be displayed,
in the meantime the and the hour digits will be
flashing. Press the
[
]
button to increase the alarm
time in 1 hour increments, until the desired hour is
displayed.
2. Press the
[ALARM]
button again and the indicator
a
and the minute digits will flash. Press the
[
]
button to increase in 1 minute increments until the
correct time is displayed.
3. Press the
[ALARM]
button a third time and press the
[
]
button to toggle the alarm between ACTIVATED
(
displayed) and deactivated (without
).
4. Press the
[ALARM]
button again. The daily alarm is
now set, and your barometer will resume its normal
time.
NOTE
If you get interrupted at any point in the alarm
setting sequence, the clock will return to its normal time
display if no buttons are pressed for 20 seconds.
BA112(EN)2
9/28/04, 3:04 PM
5
