■
Install the Clutch/Brake/Blade wires
■
Install the recoil starter
■
Install the front arm
1.
This unit was shipped with the recoil starter
removed (nuts are attached to the main
unit).
2.
Install the recoil starter with the pull handle
downward to the left of the photo.
1.
Install the front arm with the bolts and nuts
shown in the photo
⑪⑫⑬
(the bolts and
nuts are in the tool bag).
2.
First, attach the front arm to the main unit with the
longer bolt. Next, connect the front arm and the other
part of the frame with the adjustment lever SET
⑨
(do not tighten the nuts all the way leaving them a bit
loose).
1.
Drive Clutch Lever (Black): Put the drive
clutch wire (inside) through the wire holder.
2.
Drive Clutch Lever (Black): Put the brake
wire (outside) through the wire holder (it
makes the job easier when the lever is
squeezed).
3.
Blade Clutch Lever (Red): Hook the blade
clutch spring
⑦
(the spring is in the tool bag)
to the hole of the lever.
4.
Hook the end of the blade wire with the
yellow tag to the spring and then place the
wire into the wire holder.
short bolt
long bolt
long bolt
15
