2. Product Installation
Note：The door lock frame is larger than 40mm, and the door thickness can
be installed within the range of 40-50mm. If the door thickness is greater
than 50mm, a rectangular bar is required, and ask seller for it. Please check
if the list is complete after unpacking. If there is any missing, please ask the
seller in time.
2.3 Installation Precautions
2.4 Installation Steps
5
6
ORBITA
Master Card
x1
ORBITA
ORBITA
Secondary card
X2
Other: User manuel*1,
Drilling mould*1, Warranty Card*1
2
-
1
:
Product List
Front panel Back panel
Panel rubber mat
Mortise
Screw accessory kit
Key
x2
2-2:Installation Instructions
Confirm the door handing (this smart lock can be used for left-hand outswing, left-
hand inswing, right-hand inswing and right-hand outswing doors)
Interior
Exterior
Please check the accessories before installing the door lock. After completing
the installation, you can continue to install.If your door hole needs to be
punched, please seek the help of a professional lock installer. Unauthorized
handling may result in unnecessary property damage.
Mortise installation
as shown
Screw
Adjust direction as
shown
Install square rod and
screw sleeve as shown
Important
Loosen the screw in the directional
rod hole to remove the handle and
adjust the direction. Adjust the
letter corresponding to the arrow
above the square hole according to
square rod
screw sleeve
Note: The square rod spring is aligned
with the opening in the panel knob
sleeve
Install the front panel
into the panel with the
hole open
Fixed front and rear panels
A:Connect the lock mortise and power plug
B:2 screws are connected to the front panel
through the rear panel
left-hand inswing
left-hand outswing
right-hand inswing
right-hand outswing
