1. Avanti 12
2. Key (1)
3. Cup Assembly(12)
4. Standard Cushion(12)
5. AC Adapter (PN1334 3-Volt)
6. Warranty Registration
7. Instruction Book
Included In This Box
Rotorwind Watch Winders
Getting Started
Congratulations on purchasing your Rotorwind Watch Winder!
This design is unique in that it swings an automatic watch, rather than
rotating it, mimicking the natural action of the wrist. Then, with a series
of oscillations triggered by a single revolution of a low-current draw-
drive motor, power is only needed for a few seconds every 8 or 12
minutes. Extensive beta testing by hundreds of watch collectors
owning a variety of automatic watches has validated the concept.
Mounting Watch on Cushion
1. With the bracelet or strap of the watch
closed
, squeeze and slide the
cushion through the watch. The back of the watch should rest against the
Orbita logo and the strap should lie on the flat portion of the cushion .
1. Carefully unwrap the protective packaging.
2. Remove the key that is taped to the glass door.
3. Unlock and open the doors.
4. Remove cushions and confirm each module is on by pressing the o/- to the
right (-).
5. Slide the cushions back into the cup assembly.
6. Plug in the adapter to junction box located in the rear of the unit .
8. Turn the MASTER power on using power switch (o/- = Off/On).
Getting Started
12
8
Interval Settings (TPD = Turns Per Day)
8 Minute Setting: 1200 -1300 TPD
12 Minute Setting: 800 - 900 TPD
8/12 Minute Switch
A program switch allows you to select one of two
winding cycles: 8 minute (standard program) or 12
minute (extended program). The winding cycle
begins every 8 or 12 minutes based on the program
selected. Many watches that wind in both directions
stay fully wound on the factory preset 8 min. setting.
To select the extended program, remove the mounted
cup to reveal the program switch opening. Insert
a small object (screwdriver, pencil, etc) into the
opening and slide the switch to the 12 minute setting.
The factory preset position is the 8 minute setting.
