The wireless remote (another Orbit
®
innovation) allows the homeowner a
simple way to turn sprinklers on and off without having to go to the timer.
This feature is useful during repairs and sprinkler adjustments or manually
running the sprinklers for extra watering.
Remote Features:
• Turning on the sprinklers to a single station, selected stations or all stations.
• Preset watering durations of 2, 10 or 30 minutes.
• Operating range up to 300' from the timer.
some of the common uses are:
• Turning sprinklers on and off while adjusting sprinkler heads.
• Turning the sprinklers on to test repairs.
• Turning sprinklers on to provide extra water to dry sections of your lawn.
A
1 – 6 (or 12)
Individual Station Buttons
B
oN
Watering Duration
(2, 10 & 30 minutes)
C
All
Water All Stations
D
oFF
Turn off all stations
E
NeXT
Moves to next station
F
RAIN
delAY
Stops watering for 24 Hours.
Note: This remote is water resistant but is not waterproof.
Please do not submerge in water.
Using the remote
Important
: The wireless remote will not work unless the timer dial is on
AUTO
.
To Water one station:
• Press the station number.
• Press
“X” MIN
oN
to water the station for the minutes selected.
To Water All stations:
• Press the
All
button on the remote control.
• Press the
“X” MIN
oN
button to water all stations (sequentially) for the
minutes selected.
• To advance to the next station (before the current station’s watering duration
is complete) press
NeXT.
To Water selected stations:
• Press the station numbers that you want to run. (Example:
3
,
7
,
10
, and
6
).
Note
: The timer will water in sequence from lowest to the highest (
3
,
6
,
7
,
10
) no
matter which order you press the keys.
• Press
“X” MIN
oN
to water each station for the minutes selected.
• To advance to the next station (before the current station’s watering duration is
complete) press
NeXT.
Rain delay
The “Rain Delay” feature prevents the sprinkler timer from watering for 24 hours.
Note
: Use the
RAIN DELAY
button on the timer to delay watering for 48 or 72 hours.
Using the remote to activate “Rain Delay”:
• Press the
RAIN delAY
button.
• To cancel the Rain Delay, press
oFF.
installing the Wireless remote battery
• Remove the battery lid by inserting (and twisting) a flat bladed screwdriver in
the slot (located on the bottom of the remote).
• Install a 9-volt battery in the battery compartment.
• Replace the battery compartment door (ensuring that the rubber gasket is in place).
re-syncing the remote to yoUr timer
Note
: The remote and timer will already be synced. The instructions below should
only be used if you obtain a replacement remote or if your remote fails to work after
following the solutions (listed below) in trouble shooting.
• Turn the timer dial to
oFF.
• Hold down the
PRoGRAM
button (on the timer) until the
icon flashes on the LCD.
• Press and hold buttons
1
and
2
(on the remote) at the same time. When you
hear 4 beeps, release the buttons.
troUble shooting
Note
: To maximize the remote range, install the timer in an area with the least amount of
solid obstructions or electrical interference between the timer and remote.
Problem: The remote does not turn the sprinklers on.
Possible Solutions:
• The timer dial is not on
AUTo
; turn the dial to
AUTo.
• The timer is not plugged in; plug in timer.
• Low battery; replace the 9-volt battery in the remote.
• Out of range; move closer to the timer and try again.
• Remote and Timer are no longer synced; re-sync the remote.
ON
2
min
10
min
30
min
ON
ON
A
F
B
C
D
E
6 Station remote shown
