Version 01.23.2003
Page 2 of 8
**NOTE: Procedure below may vary with different model pumps. Some have a terminal type
connection instead. If you have a terminal type connection please see photos on page 7 of this handout
for connections.
Take a 7 mm driver and remove nuts securing both the hot and neutral wires. Remove wires from
terminals and replace nuts and tighten (so nuts are not lost). Unscrew ground wire and replace screw
and tighten.
Remove wire gland with an adjustable wrench and pull cable through then replace wire gland and
tighten.
On the bottom of lower assembly unscrew 4 bolts using a 13mm socket. Remove bolts and retain for
reassembly.
