Orbegozo HCE 74, Инструкция по эксплуатации

Страница: 13 / 32

HCE 74
13
If there are gas leaks, bubbles will be formed in the points corresponding to the leaks.
Close the gas valve. If there is a leak, tighten all the joints and repeat the test. Should the leak
continue, contact the supplier immediately.
IGNITION INSTRUCTIONS
Attention: before using the apparatus for the first time and after long periods of non-use, we
recommend switching on the control buttons several times alternately and without gas flow in order
to facilitate working
.
The heater can be regulated to three different heat intensities (B): MAXIMUM (4), MEDIUM (3) and
MINIMUM (2). Position 1 is used to turn on the heater, and it is also the minimum level.
The switch-on mechanism is piezo-operated (A)
1. Open the gas valve.
2. Press the power controller and turn it to Position 1 (Ignition/Low).
3. Keep pressed the power controller for 10 seconds.
4. Press the piezoelectric sparker several times while still holding down the power controller.
Once the flame is on, keep it pressed a few seconds and then release it.
5. Then, if you want to increase the power, press it slightly and turn it anticlockwise to the
desired level. Never use the heater at intermediate positions.
6. The ODS system will automatically turn off the appliance if the content of oxygen go down.
Before restarting the appliance, close the gas valve, ventilate the room and then repeat the
process.