Orbea BLUE PAPER ORCA M11eLTD PWR, Техническое руководство

Страница: 15 / 18

BLUE PAPER ORCA OMX 2020 28 | ORBEA ORBEA | 29 TECHNICAL MANUAL
CABLING
SHIMANO DI2 ELECTRONIC GROUPSETS CABLING
HEADSET SPACERS/CUTTING
THE STEERER TUBE
Due to the front brake hose being internally routed throu-
gh the fork´s blade and steerer tube, removing the fork on
Orca OMX requires to disconnect the front brake caliper
hose.
However, it is not necessary to disconnect the front caliper
to cut the fork´s steerer tube to the desired height.
Simply disassemble the ICR01 stem from the steerer tube
and remove the headset spacers (these can be split in two
halves to allow you to remove them without interfering
with the cabling).
With the fork completely inserted into the headtube and
the bike positioned so the fork is horizontally positioned
to avoid debris from falling into the headset, use a steerer
tube cutting guide and a carbon specific saw to cut the
steerer to the desired height. Measure the final height of
all components before cutting the steerer.
Internal cabling on OC Components handlebars OC1 Alloy,
OC2 Alloy, OC2 Carbon, OC1 AllRoad Alloy When cutting, be careful not to damage any components
or cables.
The installation or removal of headset spacers does not
require to remove any cables. They are composed of two
halves that allow for easy installation without interfering
with the cabling.
When installing headset spacers (40mm maximum), make
sure that the steerer tube is long enough to allow for a co-
rrect and safe installation of the stem and that the cables
are long enough.
IMPORTANT: Never install headset spacers above the
stem. The steerer tube lenght must be set so no spa-
cers are needed above the stem.
EW-RS910
SM-JC41
(Inside the stem)
To Shimano
STI Di2 lever
Cable EW-
SD50-800mm
SM-JC41
BT-DN110
SM-JC41
EW-RS910
Cable EW-
SD50-800mm