Orava VL-204, Инструкция по эксплуатации

Страница: 17 / 20

17
EN
Protective system
1.
To avoid injury hot air fan has a built-in protection system that
automatically shuts it down when it is overheated.
2.
Turn the power switch to position 0, set the thermostat to minimum and
unplug the power cord.
3.
Check that there is sufficient free space around the fan and that the
device is in the correct position. If so, you can start cooling the device.
4.
Allow the machine to cool for 8 - 10 minutes before restarting.
5. Connect the appliance to the mains and turn on the temperature
controller.
Rollover safety device
The device is equipped with a safety fuse (
7
), which switches it off in case
of tilting or overturning.
Warning!
If the device does not operate normally, turn it off and unplug it. Then take
the device to a service center!
Cleaning and maintenance
1.
Before turning off the device, first set the power/mode switch to position
. After the device has cooled down (after about 3 - 5 minutes), turn
the power/mode switch to position 0.
2. The fan must be cleaned regularly, at least 2 times a year.
3.
Before cleaning, allow the fan to cool, turn it off and unplug it.
4. Clean the device with a dry cloth slightly moistened with water. Do not
use any abrasive cleaners or solvents such as alcohol, benzine, or
thinner to clean. Do not allow water to enter inside the unit. Dry the
device before commissioning or storing it.
Warning!
When cleaning, never immerse the device in water or any other
liquid!