11
EN
Power supply
The device is powered by a built-in 4 000 mAh, 7.4 V Li-ion battery. The
battery is charged from a suitable AC adapter with a 5 V, 1 000 mA DC
output voltage using the supplied charging cable with a USB connector
and a microUSB connector.
Connect the AC adapter to an electrical outlet, connect the USB connector
of the cable to the AC adapter, and connect the micro-connector to the
micro-connector on the device.
You can also power the device from a PC by connecting the PC and this
device with the supplied cable.
Operation
1.
Charge the device before using it for the first time.
Connect the
micro connector of the supplied cable to the power micro connector (
9
)
on this unit and the other USB connector to the USB connector on the
optional AC adapter (DC output voltage 5 V, 1,000 mA) or to the USB
connector on a turned on PC. Plug the AC adapter into an electrical
outlet.
2. During charging,
Ch
will light up on the charging LED display (
7
)
and when
Fu
lights up on the display, the battery is fully charged.
Disconnect the device from the charging source and you can use it.
3. If the LED on the
Lo
display lights up, the battery must be charged.
4. If the LED on the
Er
display flashes quickly, the mixer bowl (
4
) is not
inserted correctly. Replace the blender jar.
5. If the
Er
flashes slowly on the LED display, the device motor is blocked.
Remove the hard food from the blender jar and start mixing again.
Assembly of accessories and mounting
on the motor unit
Follow the steps below to assemble the appliance for food processing.
1.
Always start by adding a liquid (such as water, milk or juice). This will
make mixing easier.
2.
Cut the ingredients into small pieces (approx. 1.5 cm pieces) to achieve
a perfect result.
3.
After pouring the liquid, add the ingredients to the rest of the drink to
60% of the bottle volume and mix!
4.
Close the blender jar clockwise. Press the on/off button (8). The device
works for about 20 seconds per switch-on.
5.
For maximum performance, you can run the device upside down and
allow the blades to reach their full speed before mixing.
6.
To end mixing after less than 20 seconds, press button (8) switches off
the device prematurely.
