Instructions for Use |
spot–
on
nxt
00.005.444-08 | EN
Date: 18.05.2021
Page 11 of 24
Look at an even surface through the magnifying glasses. By pressing the lamp on the
glasses up or down, you can adjust the way your field of vision is illuminated.
Switching off: By briefly pressing the sensor surface with your finger again, you can
switch the lamp off. When the lamp is switched off, only the charge level of the battery
is displayed.
Adjusting the brightness: In order to alter the light intensity, touch the sensor area of
the battery casing for more than one second. After this period, the light begins to
become brighter and dimmer at three levels. For control purposes the three yellow
lights also display the current light intensity. Let go of the sensor area again when the
desired level has been reached.
This value is stored and becomes active again the next time the device is switched
on. One exception is the maximum contrast level which can only be activated for 5
minutes. In order to prevent the lamp from becoming unpleasantly warm, the highest
illumination level is switched down to the middle level after 5 minutes. It is likewise
switched down to the middle illumination level after the device is switched off and
on.
Charging: When the sensory area is touched, one to three small green lamps light up.
These show the battery’s state of charge. If only one lamp is lit, this means that the
battery has only one third of its capacity remaining and should be charged before the
lamp is used again.
In order to charge the device, connect the charging cable - instead of the lamp’s cable
- to the battery unit and connect the USB plug of the charging cable to the charging
device. Now plug the charging device into a suitable mains socket.
Note:
Only use the supplied charger for charging.
Note:
Do not use the USB connection of your PC to charge the device. The
PC cannot provide the required energy. Normally, the PC will switch
off the USB interface due to overload. If it, contrary to expectation,
supplies a current, the charging procedure would take 3-4 times longer
than with the charging device.
The charging procedure is completed when the orange LED beneath the magnetic
plug completely goes out. It takes 2 – 3.5 hours.
