Error Messages
LED
Color
Description
Red
On, steady
: Card has 0% programming and erasing cycles remaining. Backup data
and copy data to a new card immediately.
Status (2)
Green
On, steady
: Normal.
On, blinking
: Locate. A user can locate a specific card in a rack of servers.
Yellow
On, steady
: Warning. A warning is caused by the following:
■ At least one flash drive reporting a high temperature warning.
■ Other component issues: Run the list and health commands in the
ddcli
utility to
determine which component has an issue.
Red
On, blinking
: Firmware fault code:
■ Run the
ddcli
utility to determine which component has an issue.
■ If no information appears, reboot the system and retry.
■ If no information appears, contact your Oracle support engineer.
On, steady
: One of the following conditions applies:
■ One or more of the SSDs has failed.
■ At least one of the SSDs has reported critical temperature.
■ Backup power rail monitor failure detected.
■ Other component issues: Run the
-list
and
-health
commands in the
ddcli
utility to determine which component has an issue.
Caution -
System Damage. If the critical temperature warning persists, you can
damage your card. Increase cooling or shut down your system to prevent damage.
Activity (3)
Green
On, blinking
: Indicates data activity on the card. No action required.
Related Information
■
“Verify Card Status” on page 38
■
Error Messages
The following sections contain service information for the Sun Flash Accelerator F80 PCIe
Card.
■
“Exception Handling” on page 56
■
“Firmware Exception Error Messages” on page 57
■
Servicing the Card
55