Oracle StorageTek 8 Gb FC PCIe HBA, Руководство по установке

Страница: 18 / 40

To Install the HBA
18 StorageTek 8 Gb FC PCIe HBA From QLogic Installation Guide • March 2015
■
“To Install the HBA” on page 18
■
“To Connect the Optical Cable” on page 19
■
“To Apply Power” on page 20
To Install the HBA
1. Attach an ESD wrist strap (see “Observing ESD and Handling
Precautions” on page 17 ).
2. Refer to your system installation or service manual to determine an appropriate
PCI-Express slot in which to install the HBA.
3. Shut down, power off, and unplug the system, if required.
4. Remove the system case.
5.
Remove the blank panel from an empty PCI-Express slot.
6. (Optional) Perform the following steps to replace the PCI bracket.
Note -
The HBA comes with a low-profile PCI bracket installed. This bracket is approximately
3.11 in. (7.9 cm) long. A standard mounting bracket, which is approximately 4.75 in. (12.6 cm),
is provided with each X-option order.
a. Remove the SFP(s), if installed.
b.
Remove the mounting bracket screws from the HBA (see
Figure 2-1
).
FIGURE 2-1 Removing the Bracket Screws
c. Remove the bracket and store it for future use.
d.
Align the new mounting bracket tabs with the holes in the HBA.