Oracle sparc M5-32, Руководство по установке

Страница: 164 / 182

154 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
▼
Power On the Server
After configuring the network addresses for the SP components, power on the server
for the first time at the Oracle ILOM prompt. This task requires two connections to
the Active SP, one using a serial connection and another using a network connection.
1. Confirm that you are logged in to the Active SP through a serial connection.
See “Log In to the Active SP” on page 148 .
2. If you see the OpenBoot PROM (
ok
) prompt, type the
#.
key sequence to
display the Oracle ILOM (
->
) prompt.
3. Using the serial connection, power on PDomain_0.
4. Log in to the Active SP as a root user through a network connection.
Replace Active-SP-ip-address with the Active SP IP address you set in “Set Oracle
ILOM Network Addresses” on page 150 . When prompted, type the default
changeme
root password to log in. Refer to the Oracle ILOM Administrator’s Guide
for Configuration and Maintenance , configuring local user accounts, for more
information.
5. Using the network connection, connect to the PDomain_0 console to view the
messages.
After connecting to the PDomain_0 console, the Oracle ILOM (
->
) prompt will not
display.
The PDomain0 initialization can take over 30 minutes to complete.
ok #.
->
-> start /Servers/PDomains/PDomain_0/HOST
Are you sure you want to start /Servers/PDomains/PDomain_0/HOST (y/n) y
$ ssh root@
Active-SP-ip-address
-> start /Servers/PDomains/PDomain_0/HOST/console
Are you sure you want to start /Servers/PDomains/PDomain_0/HOST/console (y/n) y