Oracle sparc M5-32, Руководство по установке

Страница: 160 / 182

150 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
5. Continue the installation by assigning IP addresses to the SP components.
See “Set Oracle ILOM Network Addresses” on page 150 .
Related Information
■
Server Administration , accessing the server
■
“Dual-Redundant SPs” on page 143
■
“SP Cables” on page 60
■
“SP Network Addresses” on page 64
■
Oracle ILOM documentation
(http://www.oracle.com/goto/ILOM/docs)
▼
Set Oracle ILOM Network Addresses
The SPs do not support DHCP. You must assign static network addresses to the
following components prior to powering on the server for the first time:
■
SP0 – NET MGT port on SP0
■
SP1 – NET MGT port on SP1
■
Active_SP – Active SP. If the Active SP fails, the Standby SP is assigned this
address.
■
HOST0 – The IP address for PDomain0-SPP host. The server is configured as one
PDomain, so only one host requires an address. If you reconfigure the server to
have multiple PDomains, you must assign network addresses to these other hosts.
Refer to the
Server Administration , configuring the SP network, for instructions.
You must configure these network addresses before you can access the Oracle ILOM
software over a network connection, either using the web interface or command line
interface.
1. Confirm that you are logged in to the Active SP.
See “Log In to the Active SP” on page 148 .
2. Set the gateway IP address for all SP addresses.
-> set /SP/network pendingipgateway=
xxx.xxx.xxx.xxx
Set "pendingipgateway" to "
xxx.xxx.xxx.xxx
"