Oracle Audio Technologies
PH200 Mk III phono preamplifier
6
AC Power input
Connect the cylindrical DIN plug to the rear of the
PH200 Mk III, the electrical cord to the power
adaptor and the electrical wall outlet.
Operating Instructions
Operating your sound system should always be
done by following an orderly ritual both when turning it
ON or OFF. One should always begin by powering up
his source components, followed by the powering up of
the preamplifier / amplifier section after a moment.
Following this procedure will prevent hearing a loud
thumping sound generated by source components as
they charge up their electronics. Powering down your
sound system should always be done by beginning with
powering down the amplifier, preamplifier to then finish
with the source components.
Your PH200 Mk III is sensitive to the magnetic field
generated by amplifier transformers and power cords in proximity. Position it as far as possible to amplifiers and
away from power cords. This will prevent this unwanted energy to pollute the signal with noise which thus would
lessen the performance of the PH200 Mk III and your musical experience.
Specifications
Frequency response :
20Hz - 20KHz @ +/- 1db
Total Harmonic Distortion :
<0,05% @ 20Hz – 20kHz
Moving Coil input load impedance :
100, 200, 511, 1k, 1.5k and 47k Ohms
Moving Magnet input load impedance :
47k Ohms
MM capacitive load :
150 pico farad
Input sensitivity :
0,35 mV
Gain options : 42db, 52db, 62db, 73dB
Gain selection for MM cartridge : Must be set at 42 dB & 47k Ohms
Accuracy of the RIAA standard curve :
+/- 0.1db
Signal to noise ratio :
> -80db
Dimensions :
9.5" X 12.25" X 2.25"