Oracle MICROS 720, Руководство по установке

Страница: 17 / 34

3.
To take the tablet out of standby mode, quickly push the Power button.
The display powers on in a few seconds. The wireless connection may take several
seconds to re-establish.
4.
To power off for extended storage, use the Shut Down function provided in the
operating system software.
5.
To perform a hardware shutdown as means of recovery from tablet lockups, hold
the Power button for four to six seconds.
Use precaution. This type of shutdown is only advisable for troubleshooting and
not as normal operation.
Barcode Scanner Configuration
The Barcode Scanner is an optional configuration of the Oracle MICROS Tablet 720. It
comes pre-installed and is programmed for the most common terminal and
communications settings.
If you need to change these settings, programming is accomplished by scanning the
barcodes provided by Honeywell International Inc., the manufacturer of the barcode
scanner engine. The N36XX Decoded Engine User Guide by Honeywell International Inc.
provides these scan codes. It can be found on the Honeywell International Inc.
website.
Using the Barcode Scanner
The Barcode Scanner has a view finder that projects a bright red aiming beam
corresponding to the scanner’s field of view. It can read both 1D linear barcodes and
2D matrix symbols.
To scan single or multiple barcodes/symbols:
1.
Hold the Barcode Scanner at an appropriate distance from the barcode/symbol.
2.
Pull the Scanner Trigger, and then center the aiming beam on the barcode/symbol.
Tips for using the Barcode Scanner:
• For the best read, position the aiming beam centered over the barcode/symbol.
• For a good read, position the beam in any direction, such as horizontal,
vertical, or diagonal.
• The aiming beam is smaller when the scanner is closer to the barcode/symbol
and larger when it is farther from the barcode/scanner.
• If the barcode/symbol is laminated or highly reflective, it may be necessary to
tilt the barcode/symbol to prevent unwanted reflection.
Barcode Scanner Configuration
Setup and Configuration 2-3