Securing the Workstation Display to a VESA Mount
The Workstation 6 Series supports mounting the workstation display to a VESA mount.
The workstation display is engineered in accordance with the Flat Display Mounting
Interface (FDMI) Standard, otherwise known as the Mounting Interface Standard
(MIS), defined by VESA. The VESA standard defines the dimensions of a display’s
four-hole attachment panel and dictates the placement of the hole pattern on the back
of the workstation display.
When choosing a mounting bracket, look for VESA-compliant brackets.
During installation, follow the directions provided with the mounting bracket. When
mounting the workstation display to the bracket, the Workstation 6 Series External
Power Supply (400351-038-PT) is required and includes the following:
•
Workstation 6 Series External Power Supply
•
4 Stainless Steel Spacers (8.15mm)
•
4 Stainless Steel Washers
The stainless steel spacers allow for clearance of the external power supply. When
mounting the workstation display to the bracket, insert the washers and spacers
between the bracket and the workstation display, and then secure using the bracket’s
mounting screws.
Securing the Adjustable Stand to a Counter
The Adjustable Stand is a mounting option for each configuration of the Workstation 6
Series. When using this option, ensure that the Adjustable Stand is properly secured
to a counter
1.
Place the Adjustable Stand flat on the counter surface, and then turn the unit
upside down.
2.
Unscrew and remove the fifth rubber foot located in the upper middle of the stand.
This hole will be used to secure the Adjustable Stand to the counter. The location
is indicated below.
Chapter 6
Securing the Workstation Display to a VESA Mount
6-18
