Oracle Fabric Interconnect F2-12, Руководство по установке

Страница: 86 / 118

Log In to the SP (Network Management)
c.
Set the switch's host name.
See “Run the Oracle Fabric OS Configuration Wizard” on page 102 .
Note -
If the Oracle Fabric OS Configuration Wizard does not start, you can set the SCP IP
address and netmask, and host name through the
set system management-interface
,
set
system management-interface -netmask
, and
set system hostname
commands in the
Oracle Fabric OS.
7. (Optional) If the SER MGT connection is temporary, you can disconnect it now.
8. Log in to the SP through the management network.
See “Log In to the SP (Network Management)” on page 86 .
Related Information
■
“Connect the SER MGT Cable” on page 75
■
“Connect a Serial Management Device to the SER MGT Port” on page 77
■
“Connect Power Cords” on page 77
■
“Power On the Switch” on page 81
■
“Log In to the SP (SER MGT)” on page 82
■
“Assign a Static IP Address to the SP” on page 83
■
“Log In to the SP (Network Management)” on page 86
Log In to the SP (Network Management)
1. Identify the prerequisite and subsequent installation tasks that you must
perform in conjunction with this task.
See “Installation Task Overview” on page 11 .
2. Open an SSH session and connect to the SP by specifying the IP address you
previously configured.
For example, type:
% ssh -l root
IP_address
password:
password
->
where IP_address is the IP address of the SP. Initially, the password is
changeme
.
86 Oracle Fabric Interconnect F2-12 Installation Guide • November 2016