Carefully align the edges of the card with the top and bottom card guides. Then, push the card
along the length of the card guides until the rear connectors on the card engage the mating
connectors on the target shelf backplane.
5. Push in the top and bottom inject/eject clamps (see
Figure 12: E5-APP-B Card Inject Levers
Figure 12: E5-APP-B Card Inject Levers
This locks the card in place and ensures a strong connection with the pins on the target shelf
backplane.
6. Slide the E5-APP-B H/S switch (4) down to the LOCKED position (see
Inject Hardware Switch, LOCKED
Note: When the Ejector switch goes from UNLOCKED to LOCKED, the E5-APP-B Eject Status
LED blinks red as the E5-APP-B card goes online.
43
910-6535-001 Revision D, February 2014
Installing and Removing E5-APP-B Cards
Hardware and Installation Manual