19
Installation Guide
2) Using the web browser on a PC in the same subnet as the unit. The unit configuration
pages can be accessed using the unit IP address or DNS name. The unit has DHCP factory
enabled. When the unit is connected to a DHCP network for the first time, an IP address
is automatically assigned by the network switch or router it is connected to. Most routers
will have the facility to enable DHCP and DNS, if it is not available, contact your network
administrator.
The default DNS address for each unit is factory set as the serial number. This address can
be found on the serial label on the unit or via the packaging the unit came in.
If DHCP and DNS are not available, the IP address can be found by connecting an analogue monitor to
the balanced video output connection of the camera. The unit IP address is displayed on the analogue
video output for 10 minutes from powering the unit on.
The DNS or IP address can be typed directly into the address bar of a web browser.
Note:
The DNS address of the unit can be edited to something more memorable or meaningful than the
serial number by editing the System Name option in the System Attributes page.
Zero_conf configuration
If a permanent IP address is not assigned to the unit, it will attempt to contact the DHCP server every
time it starts up, and periodically thereafter. The unit support zero-configuration networking (sometimes
known as Bonjour), this enables automatic discovery of computers, devices, and services on IP networks.
Zero-configuration uses industry standard IP protocols to allow devices to automatically discover each
other without the need to enter IP addresses or configure DNS servers. By loading a suitable free add-
on to your web browser such as Bonjour for Windows for Internet Explorer or DNSSD for FireFox zero
configuration devices such as this unit can easily be discovered and accessed.
Accessing the Configuration Pages
The unit is configured using the on-board configuration pages. To access these:
1. Launch a web browser, preferably on a PC on the same subnet as the unit or use the infra-
red remote control and a monitor connected to the dome video output.
External Dome : connect an analogue monitor to the video out connectors in the interface
box via a balun.
Internal Dome : via the composite output on the connector block of the internal dome.
Refer to ‘Installation’ chapter wiring schematics for connection information.
Содержание Dedicated Micros PTZ
Страница 1: ...Dedicated Micros PTZ Dome Oracle dome Installation and Configuration Manual...
Страница 139: ...139 Installation Guide...
Страница 140: ...www dedicatedmicros com MI I ODH E1 1...