OPW M00-051.00 FSC3000, Руководство по настройке через командную строку

Страница: 39 / 181

Section 6 Pump Setup
6.1 Mechanical Pumps
6.1.1 Configure PCT # (# = 1 to 8)
Originally, the FSC3000
™
was designed to control mechanical pumps using a board called a PCT (Pump
Control Terminal). The ability to control mechanical pumps with an integrated PCT in the K800
™
Hybrid
terminal and a board called a PCM (Pump Control Module) has since been added. The configuration of the
different mechanical pump interfaces, however, is still the same. The first step is to indicate the kind of
mechanical pump interface that the system will interface with. The system can support up to four (4) PCTs.
Even though the interfaces are not all the same, they are still configured as PCTs.
If using PCT (Mechanical), up to eight (8) positions per PCT (4 PCTs allow for 32 pumps) are supported.
If using PCM/K800 PCT– up to four (4) positions per controller (8 PCMs allow for 32 pumps) are supported.
Doc. No.: M00-051.00 Rev.: 10
Page 39 of 181