•
Install safety cover and guide table.
•
Set the temperature and speed required.
•
Laminate a piece of same material too check if foil on the rollers is tensioned well.
If not, adjust them using knobs on rollers or with the roller tension handle.
The handle is on the right side of equipment.
•
The equipment is ready to use.
4 CONTROL PANEL
TEMP
- Temperature adjustment up & down
SPEED
- Speed adjustment up & down
STBY
- Standby mode, temperature is set to 85°C
MEAS
- Measures actual roller temperature
STOP
- stops the rollers
REV
- reverse function
HOT
- Initial setting 110°C , speed 3
COLD
- Cold laminating
MEMO
– Memory settings
On the display you can find also information about actual work mode: cold lamination, hot
lamination, running rollers and running fans
10
5 PROGRAMMING MEMORY
Using MEMO button you can save your individual settings:
•
Push the MEMO button for 2 seconds. The temperature and speed on display will blink.
•
Using temperature and speed button to set the required settings.
•
Press the button required 1 to 5 to save your settings.
Factory pre-set memory value
Attention!
If you do not use the equipment for about 1 hour the temperature will automatically
go to 85°C.
If you press the STBY button, the temperature will go to 85°C.
If you do not use the equipment for 1 hour after you have pressed the STBY mode,
the Power will turn of automatically.
MEMO
TEMPERATURA (
O
C)
PRĘDKOŚĆ
1
50
2
2
110
2
3
115
2
4
120
3
5
125
3
