Putting and fixing the equipment on to the stand with the 4 M10 setscrews
Screw through the bottom of MasterPress stand the 12 long regulator screws
string them through the holes of catches
Smaller set of catches
catches
regulated screws
screws M10
If the machine was exposed to temperatures below 0˚C, care should be taken
to warm the equipment up slowly in normal room temperature to avoid
condensation and damage to the electrical circuits and processor
it may be connected to mains after a reasonable time.
To ensure operator’s safety, the equipment must be connected to the
mains power only through the original cord. The mains socket must be
in accordance with electrical and earthing regulations and the supply
voltage specified on the equipment and technical data.
Failure to do so can cause electrical shock or fire and cancelling the
guarantee.
Preparation for work:
1. Insert the plug into the mains socket
2. Mount the roll of foil on the foil holder, feed it over the heater and fix it to the
foil winding roller. Foil width must not exceed 230mm.
2.
Switch the power supply on (the main switch is located at the back of the
machine)
– after few seconds the temperature starts increasing
NOTE!
The equipment has a factory setting t
emperature of 100˚C. This setting on average
provides the best results for hot print stamping and embossing. However, if the
stamping results are not satisfactory which depend on the type of foil and cover,
it may be necessary to change the settings by pressing
[▲] or [▼] button to raise
or lower the temperature using button marked (Stemp). Current temperature is
indicated on the right side of display (Temp).
1. Wait until the set heater temperature is reached,
„READY” will appear on
display and a sound, a bleep which means that it is ready for operation).
2. The machine reached required temperature and is ready to operation
Hot print stamping and embossing:
1. Take the frame out of the heating slot
NOTE! If the frame was previously used or on the heater unit, remove and
wait 5-10 minutes until it gets cold enough to handle.
Burn Hazard
2.
Put the MP frame on the frame holder. It is safer, easier and quicker to put
and remove typeface fonts into the MP frame.
3.
Compose the required text in the MP frame lines with the typeface and
suitable fonts using the tweezers supplied.
4.
NOTE! The fonts should be put in and taken out using the special
tweezers. the ends of the tweezers fit into the holes on the typeface
fonts which makes it easy to lift. The holes and the letters show you the
correct way and help to distinguish between the top and bottom of the
letter. The bottom hole is closer to the bottom of the letter. On the
smaller typeface there is only 1 at the bottom for the letter.
5.
Lock the text in the frame by the stops at each end.
6.
Insert the frame to the heating slot and wait about 1 minute until the typeface
fonts are hot check the temperature on the led display.
7.
Set the side guides to position the cover in suitable to the frame
8.
There is no need to put anything under the cover. The equipment
automatically adjusts heater height for the material thickness.
9.
Set the pressure required by adjustment large black knob on the front of the
equipment to the required pressure 1-10, 10 is the maximum pressure.
10. You must adjust the pressure to the cover type.
11. Insert the cover under the heater in the guides. If it is necessary, use
additional resistance angels by putting them under the sidegauges with
straight side face to cover.
12. Slowly pull the handle down till it stops.
13. There will be a bleep signal and on the LCD you will see END.
14. Lift the handle to the fully open position. The foil will wind on ready for the
next. The amount of foil movement can be adjusted to suit the job.
15. Take the cover out
– your documentation is ready!
