OPUS CS 2208 AF • User giude
GB
• There is an optical photocell in the feed slot, when paper is put there it automatically switches
on the shredder.
• The equipment should be placed on a level floor.
• The shredder is on 4 caster wheels and the two front caster wheels can be locked to keep it in
position.
• Before plugging in the equipment, ensure there is nothing in the slots, like paper, cards
or CD/ DVDs and that the paper bin is fitted properly, there is a micro switch which if the bin is not
fitted correctly the motor will not start.
• There is a three position slider switch marked, FWD, AUTO, REV and push in, on & off power switch.
• If you set, the slider to FWD it will keep the cutting blades going all the time. It is only for when
you shred very small pieces of paper and to clean some paper that may not go through on auto.
• Push the power switch in and a green LED light will come on. Then set the slider to AUTO now
it is ready to work.
• Insert paper into the feed slot on the top. NOTE! Paper should be only put in the middle of the slot.
• The equipment will start automatically after inserting the paper.
• Maximum paper width of 225mm. If the pages are wider, cut or fold to fit the slot. You can only
shred 8 sheets of 80 g/m² paper at a time.
• For shredding up to 60 sheets of paper using the auto feed system, lift the lid on the top which
also acts as a rest for the paper, switch to auto and place the sheets and let them go through and
the shredder will switch off when it has finished.
• If the temperature of the electric motor gets to hot shredder will automatically turn off and a Red
light will flash.
• When the electric motor has cooled down the red light will go off and then motor will be ready
to start again.
• Shredding credit cards. The shredder shreds only one credit card or one CD/DVD at a time.
• It is impossible to shred paper and credit cards or CD/DVDs at the same time.
• If too many pages of paper are inserted into the slot, it will cause the paper to jam inside the
cutting blades.
• Pull out the surplus jammed/stuck paper and slide the switch to REV to (reverse) the paper out
and then switch to “FWD” (forward) to shred any paper scraps left in the cutting blades.
• If it will not solve the problem, contact the dealer or the service team.
3
OPERATION
7
• Before clearing the shredder ensure that the main power switch is switch off and the green LED
is off, then unplug the equipment from the mains socket.
• When the shredded paper bin gets overfilled, it may cause problems and paper will go inside
the mechanism feed and there is a risk of fire. Pull the bin out, remove shreds and re-install the
bin under the shredder.
• To avoid problems please clean the shred bin regularly before it overfills.
• Cleaning the housing. Wipe the cover of the shredder with gentle home detergent or a damp
piece of cloth.
• Do not put the equipment into water.
• Do not wipe the unit with petroleum, thinners, alcohol or solvents “” they can cause permanent
damage to the housing and the plastic.
4
CLEANING
Содержание CS 2208 AF
Страница 1: ......
