User’s guide OPUS cityLAM A4
Healht & Safety precautions:
●
Before operating the equipment please read the Health & Safety precautions, manufacturer
recommendations and the operation manual.
●
The operation manual should be easily available at any time for the operator.
●
The equipment should be installed on sturdy and level surface near a 220-240 V, 50Hz socket.
●
The equipment should be protected against dust and moisture
●
The equipment must not be placed near the heating or ventilation units.
●
The equipment must not be used in vicinity of inflammable liquids or gases
●
The power supply cable should be protected against damage and must not be used to pull the
equipment or to remove the plug from the socket.
●
The equipment must be kept away and out of from reach of children.
●
Danger! The equipment contains rotary elements. Ensure long hair, loose jewellery, ties and other
loose pieces of clothing are keep away they can be get entangled in the rolls.
●
The equipment must not be used for any other purposes than those indicated in the instruction
manual.
●
It is necessary to check and supervise if the equipment is operated correctly.
●
In case of any malfunctions, you must contact the dealer or service team.
●
The equipment must not be located outside and should be operated in a room temperature higher
than +8 °C.
●
Before removing any covers from the equipment, remove the power plug from a mains socket.
●
Using inappropriate lubricants causes a fire hazard.
●
Any repairs must be carry out only by authorised staff.
●
The equipment must be operated according to general Health & Safety rules.
●
Do not leave the equipment in operation without an operator.
●
After work it is necessary to turn the equipment off by the switch on unit after the cooling down
procedure, next remove the plug from a socket
Manufacturer’s recommendations:
●
Use only recommended supplies and accessories.
●
Do not put into the laminator documents thicker than 1 mm. The laminated material should always
have similar properties
●
Remove the mains plug from the socket before moving the equipment or during longer none
operation.
●
If the equipment is switched on and is not operated for more than one hour, it can be overheated.
To avoid bad quality lamination put 2 or 3 sheet of A4 paper through in order to cool the rollers
down
●
Always insert the laminating pouch with the close end into the laminator first. Putting the open
end first can cause bubbling and the film being stuck on the rollers inside the laminator.
●
In case of a document being stuck inside the laminator, use reverse function REV switch.
●
Tailor cut pouch can make the rollers sticky and dirty and wind round them use a carrier.
●
Remove all metal elements (staples & paper clips, etc.) before laminating the document.
●
NOTE! The equipment contains heater elements, be aware high temperatures!
●
NOTE! Not compliance with the rules and recommendations above can void the
Guarantee/Warranty.
7
