AthAbAscA EAsEL
— ASSEMBLY INSTRUCTIONS
Page 4
Putting it all together:
9.
Just like the for the (7) Top Canvas
Holder, place the last (C) Metal Guard
in the flared in channel of the (1) Center
Slide Post Support. Then feed the flared in
channel onto the back side of the flared out
rail of the (6) Center Slide Post (opposite
side than the (7) Top Canvas Holder. Don’t
worry they will slide past each other.)
10.
Lay the Easel on it’s front, careful that
the Canvas support does not twist but stays
in line with the (3) Ratchet Post. The (9)
U-Shaped Bar goes around the (3) Ratchet
Post and attaches to the back of the (8)
Canvas Brush Tray by the (I) 2 Long Bolts
with Springs (should already be in the (9)
U-Shaped Bar) and 2 (B) Bolt Adapters.
Make sure the
bevel on the
inside of the
(9) U-Shaped
Bar bevels up
and away from
the (3) Ratchet
Post (smaller
opening on the
bottom.) The
(B) Adapters
go into the
holes on the
bottom of the
(8) Canvas
Brush Tray.
The (I) Bolts go in the back of the (9) U-Shaped Bar and through the holes at the back
of the (8) Tray. You may need to push with the Hex Wrench to compress the springs
enough to be able to screw the (I) Bolts in. Make sure you make the same number of
turns on both the (I) Bolts so that you have the same amount of tension on each side.
You should be able to pull the (9) U-Shaped Bar away a little so that it springs back
against the (3) Ratchet Post when let go. This gives the Canvas Support some leeway for
when it is put in its forward position.
11.
Tighten up the rest of the screws and bolts, stand your new easel up, extend the
back leg and get painting.
11.
9.
8.
10.
10.
10.
Bevel
(Pg. 3)
