OPTOTRONIX AURORA LCU EV2O, Руководство пользователя

Страница: 11 / 16

11
Battery Test
The battery test function of the AURORA LCU
EV
2
O
can be started at any time by short
pressing the “Set” button, during the battery test (about 3 seconds) the connected LEDs are
disabled!
At first, 2 of the blue status ‐ LEDs are blinking up, showing which battery type is programmed
(Lipo, LiFe, or BEC).
The voltage level of the battery can be read with the 6 blue status ‐ LEDs of the AURORA LCU
EV
2
O . If 4 LEDs are active, the battery state of charge is 60 ‐ 75%. If no LED is active any more,
the battery should be disconnected and recharged.
If the programmed battery voltage becomes critical, the AURORA LCU EV
2
O completely shuts
down after a fast flashing ‐ sequence of the green Mode LED to protect the battery. It can only
be restarted by reconnecting the battery.
Stand Alone Mode
This “autonomous operation mode” mode allows to operate the model lighting, even if the
receiving system is not active (e.g. exhibitions or showroom), or may not be switched on (e.g.
Building competition).
Activate all light outputs which should be active and then push the button for at least 2
seconds. The 2 ‐ second ‐ long ‐ push always will be confirmed by flashing the green Mode LED
three times. The blue Signal LED now starts to blink, the Stand Alone mode is active and the
electronic is no longer controlled by the receiver signal!
Exit the Stand Alone mode by pushing the button 2 seconds again.
Programming Mode
Connect the power supply and receiver signal (or a servo tester) to the AURORA LCU EV
2
O .
Hold the button permanently pushed before the startup sequence is completed.
If the programming mode has been successfully started, all blue status ‐ LEDs are flashing very
quickly for 4 seconds. Release the button as soon as the flashing starts.
Now you entered the Programming Mode.
>90%
15%
30%
45%
60%
75%