OptoTest OP280MT, Инструкция по эксплуатации

Страница: 6 / 12

OP280MT
5 of 8
On | Off Button
Turns the unit on or off. When turned on the unit starts up with
sequence #1. This is indicated with LED #1 blinking. The unit will
stay on until turned off again.
Pressing the On/Off button for a few seconds will cause the unit
to display the level of the battery charge. The number of LEDs
illuminated is proportional to the battery life (12 LEDs=full charge).
Select | Advance
When the LED is blinking, pressing this button turns on the first
combination of lasers for the selected sequence. The LED will go
from blinking to solid.
When the unit is operating the lasers (LED solid) pressing this button
will advance to the next sequence step. The next combination of
lasers will turn on.
If the Advance button is pressed and held for a few seconds
the unit will automatically cycle through the sequence steps.
This automatic play of the sequence is stopped by pressing the
Advance button again.
Select Sequence
When the LED is blinking, pressing this button switches to the next
programmed sequence. The unit stores up to twelve sequences,
4 pre-programmed and 8 user programmable. The sequences are
programmed using the OPL-280MT application software.
Supported OP280MTs are configured to work in conjunction with the
OP480MT to quickly analyze the cable type (A, B, C, etc). To put the
OP280MT in the proper mode to function with the OP480MT, press
and hold the “Select Sequence” button for 5 seconds and release.
When ready, the unit will flash LED #1 until the button is released. In
this mode the LASERs will quickly cycle through all available LASER
sources and be easily recognized by an OP480MT.
Front Panel Operation