Addres:A-14,Haide Building,the Intersection of Nanxin Road and Haide Second Road Nanshan District,Shenzhen,P.R.China
Tell:0086-755-26400198/0086-0755-26400288
Fax:0086-755-26411001
OP-S4009 Ethernet Switch User’s Manual
OP-S4009 Ethernet Switch User’s Manual
The switch can sit on desktop or any flat surface with adequate
space and ventilation. If you want to place it onto a shelf, make sure
the shelf can withstand the weight of the switch.
Step 1: Simply put the switch on the desired place.
Step 2: Ensure the switch receives good ventilation.
�
Connecting to Power
Locate the provided AC power cord.
Step 1: Connect the AC power cord to the receptacle at the back of
the switch.
Step 2: Attach the plug into a standard AC outlet with a voltage
ranging from 100 to 240 VAC.
Step 3: The power LED on the front panel will come on then.
�
Connecting to Network
Step 1: First, ensure the power of the switch (and end devices) is
turned off. (It may cause electric shock or any possible harm to
you if the power is not switched off. )
Step 2: Prepare cable with corresponding connectors for each type
of port in use.
Step 3: Connect one end of the cable to the switch and the other
end to a desired device.
Step 4: Once the connections between two end-devices are made
successfully, turn on the power.
Now the switch is operational.
A. Connection between Ethernet Switch and terminal unit.
The PC can be collected by with the Ethernet Switches by a 5
twisted pair wire. That is to say, the PC can be connected to one of
the fast Ethernet port by the twisted pair with RJ-45. The LED
should show on once connection. Or please check the internet card
and cable of PC and connection situation of Ethernet Switch.
B. Connection between Ethernet switch and Hub ( or Switch)
A Hub or switch of can be connected with the Ethernet Switch by a
twisted pair wire. The fiber port of Ethernet Switches should be used
as UPLINK if it is connected by fiber cable. One of 7 UTP can be
used as UPLINK if it is connected by a twisted pair wire.
C. Connection between fiber port: with other devices with fiber
port
The Fiber port of this Ethernet Switch can be connected with other switches or
converters with fiber port. But please do not connect SM and MM. That
is to say, SM device must be connected with SM ones and MM
device must be connected with MM one.
Note
：
1. Please be advised that the POE port is only for PD. That’s to say,
this device can only accepted power from other devices via network
cable.
2. The voltage and current for POE port is +3.3V~+5V/2A. Do pay
attention to control the voltage within this range in order to avoid
