Optoma WHD200, Руководство пользователя

Страница: 18 / 25

16
B. Please make sure source devices have been power on; also try to re-plug the HDMI cable to
make sure the HDMI connector had settled well.
C. If there is no video displayed and OSD displayed “Not Supported Format”, this is an indication
that the video frame rate from source devices is not supported, please refer chapter 5 to
switch a supported video timing.
D. If you have more than one pair of WHDI DEVICE, each transmitter and receiver should be at
least 6.5 feet away from one another. If both the transmitter and the receiver exist in the same
room, the suggested the distance between the two is 6.5 feet minimum.
(9)
On Screen Display (OSD) vs. RCU Instruction

On Active mode, Press the POWER button on the top of Receiver or press RCU Power button
point to receiver, receiver enter Standby mode and transmitter’s HDMI out is on.
OSD Displayed: (Display 3secs and then enter Standby mode.)
ON

On Active mode, Press the POWER button on the top of Transmitter or press RCU Power button
point to transmitter, both transmitter and receiver will enter Standby mode.
OSD Displayed: (Display 3secs and then enter Standby mode.)
OFF

Press the INFO button on the RCU, and Signal Quality, Source, Channel and resolution will be
displayed for user reference.
OSD Displayed: (Press again for exit.)
HDMI1 CH10 1280x1024
= OFF