58
English
Appendices
The screws on the
lamp cover and the
lamp cannot be
removed.
The projector
cannot be turned
on if the lamp
cover has not been
placed back on the
projector.
Do not touch the
glass area of the
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth to clean the
lamp module if it
was accidentally
touched.
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the “
” button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws on the lamp door.
1
5. Slide the lamp door sideways, then hook it round the bottom of the projector.
2
6. Unscrew the four screws on the lamp cover.
3
7. Unscrew the two screws on the lamp housing.
4
8. Lift up the lamp handle and remove the lamp module slowly and carefully.
5
To replace the lamp module, reverse the previous steps.
9. Turn on the projector and use “Lamp Reset” after the lamp module is
replaced.
Lamp Reset: (i) Press “Menu”
(ii) Select “OPTION”
(iii) Select
“Lamp Settings”
(iv) Select “Lamp 1 Reset” or “Lamp 2
Reset”
(v) Select “Yes”.
1
2
3
4
Lamp1
Lamp2
5
