Optoma CM-E75X Скачать руководство пользователя страница 2

X

 

 

INSTALLING THE CEILING MOUNT  

 

1.  Select an appropriate projector mounting location 

and extension shafts (Part No. 9, 10, 11) needed, if 
any, to get the required projector position. Place 
the Heavy Duty Ceiling Mount Assembly (Part No. 
3) in the desired location, using the mount as a 
template; mark the two slots onto the mounting 
surface.  

2.  Refer to the TOGGLER® brochure “Anchoring 

Solutions,” (Part No. 8). Then follow the instructions 
that are appropriate for the type of surface on 
which you will be attaching the Heavy Duty Ceiling 
Mount Assembly.

 Note: if you are using the 

Alligator® anchors, they must be installed in 
the center of the ceiling joist or beam. 
Installation along the edge of the joist can 
cause splitting.

 

Y

 

Z

 

3.  Drill the appropriate sized hole at each marked 

location and insert the previously selected anchor 
(Part No. 5 or 6) into place. 

4.  Place the Ceiling Mount Assembly onto the 

anchors and insert two 2-inch wood screws (Part 
No. 7). Tighten until snug. 

Do not over tighten.

 

 

INSTALLING THE PROJECTOR MOUNT  

 

1.  Place the PROJECTOR upside down on a flat 

surface. Being careful not to damage the projector. 

2.  Place the Heavy Duty Projector Mount Assembly 

(Part No. 1) onto the projector, lining up the three 
mounting holes. Using three of the Phillips 
Projector Mount Screws (Part No. 2), secure the 
mount to the projector.  

 

FINAL ASSEMBLY AND ADJUSTMENT 

 

1.  Attach the required extension shafts, if any, using a 

1/4” star washer (Part No. 12), between each joint. 

2.  On the Heavy Duty Ceiling Mount Assembly (Part 

No. 3) loosen the hexagon shaft and ball joint, 
using the hex wrench (Part No. 13) to unscrew the 
locking screw in the ball joint. 

3.  Raise the projector and mount assembly into 

position under the ceiling mount. Screw the two 
assemblies together by twisting the hexagon shaft, 
from step 2 above. Make sure you placed a star 
washer in this joint also.  

4.  Using two wrenches, tighten the two hexagon 

shafts and extension shafts, if any, compressing 
the star washers. 

5.  On the Heavy Duty Projector Mount Assembly (Part 

No. 1) loosen the ball joint by unscrewing the 
locking screw. 

6.  Now position the projector and tighten the two ball 

joints firmly into place using the hex wrench. 

 

APPENDIX: PARTS LIST 

 

# Description 

Qty. 

Projector Mount Assembly 

Projector Mount Screws 

Ceiling Mount Assembly 

TOGGLER® TC® anchor (not shown) 

TOGGLER® AF6 Alligator® anchor  
(not shown) 

TOGGLER® Red Key (not shown) 

#10 x 2” Truss Head Phillips Screws 

“Anchoring Solutions” brochure (not shown) 

24” safety cable  

10 

6” Extension Shaft (not shown) 

11 

9” Extension Shaft (not shown) 

12 

1/4” Star Washers 

13 Hex 

Wrench 

 

 

 

T.M. 

715 Sycamore Drive Milpitas, CA 95035 

Отзывы: