Copyright 2011 Bit Cauldron Corporation
Page 6 of 24
Connecting the Optoma 3D-RF Emitter to Optoma 3D-XL converter box
Use the guide in Connections: Optoma 3D-XL converter
box with 3D Emitter Port to properly connect the Optoma
3D-RF Emitter. When the Optoma 3D-XL converter box is
turned on, the Optoma 3D-RF Emitter will turn on as well.
The LEDs will display a red moving pattern while the
emitter is attempting to acquire a 3D signal and until a
signal is found. If the emitter searches for a signal for
longer than 60 seconds, a signal is not found. Ensure that
the 3D ready projector is in 3D mode. In addition to
setting the 3D ready projector in 3D mode, you must also have 3D content playing in order to find 3D
signal (LED’s turn green.)
Upon finding a 3D signal, all LEDs will turn green for
approximately 60 seconds and then turn off. Once the LEDs
indicate a 3D signal, the Optoma 3D-RF Glasses can be used
to experience 3D. If the image when viewed through the
Optoma 3D-RF Glasses is fuzzy, has ghosting, or is out of
polarity, see Manual Performance Tuning Mode: Using the
Joystick to Manually Tune Performance.
