4 |
S t r e a m L i n e 2 0 1 7
STEPS TO A SUCCESSFUL INSTALLATION
1.
Install the junction box/power supply
2.
Install the fixture
3.
Connect power from the power supplies to the fixture
DANGER:
Ensure that the power source is off before wiring the power supply or connecting fixtures.
Failure to do so will result in serious injuries or death.
1. INSTALL THE JUNCTION BOX/POWER SUPPLY
Determine a location for the junction box/power supply. Verify the length of StreamLine Luminaire that
can be supported by the power supply. Multiple power supplies are required for installations that
exceed the allowable length per power supply. (See Luminaire Length Table)
2. INSTALL THE FIXTURE
First, install the mounting clips in the marked locations with the appropriate length and type of screw
for the surface that it is being mounted to (See diagrams below).
Note: Use a level, or chalk line, to ensure that mounting clips remain linear.
When the clips are securely in place the fixtures can be mounted by simply pushing the fixture into the
secured clips that are mounted to the surface.
Note: It can be helpful to install the fixture on one side of the clip and apply pressure to the
opposite side to snap the fixture into place.
For foam tape or magnetic strip mounted fixtures, simply remove the adhesive liner, place the fixture
in its pre-defined position and apply pressure to activate the adhesive.
Note: Magnetic strip mounted fixtures will arrive with the magnets already together and one
side attached to the fixture. It is recommended that the magnets remain together while
positioning the fixture for installation, which will prevent mismatch during final installation.
Once the fixture is positioned in the mounting location, the magnets may be detached and
pressure applied to activate the adhesive.
