X6R/V3R-TP
21 / 27
rev. 2.4
Example 2
X6R/V3R-TP devices are used mostly as a channel extension to main fibre optic Optocore network nodes. In this
example two FX devices are connected with dual ring redundant network. X6R/V3R-TP devices are used as an
analogue extension. On the one end three TP devices extend the channel count of X6R-FX unit. This group of
devices can be used as a stage box with 40 microphone inputs and 16 line outputs. Furthermore distance
between each device can be 100m, so each device can be located in a different place of the stage. On the other
end of the fiber loop DD2FR-FX, with two MADI ports, is extended by two TP devices. MADI ports can be
connected to 3
rd
party consoles. With OPTOCORE CONTROL software Emulation Mode can be set therefore
consoles may control gains for all OPTOCORE mic preamps directly without additional control unit.
Fig. 2: Connection of four X6R-TP units, one V3R-TP, one X6R-FX and one DD2FR-FX.
Optocore network shown above is also capable to transport 100Mbit Ethernet without any additional equipment as
well as control data e.g. RS485/RS422. Each X6R/V3R-TP device is equipped with two AES/EBU ports which can
be used as a additional digital I/O. All setup, routing, configuration should be performed with OPTOCORE
CONTROL software.
OPTOCORE network in this configuration example requires no additional cabling for WORD CLOCK. Sync
signals are transported simultaneously with OPTOCORE/SANE signal.
