OPTO-EDU A16.2615-L, Инструкция по эксплуатации

Страница: 2 / 23

ATTENTIONS
1. Please clean sample-touching part after using.

Following the Fig.1 step to move the instrument, make sure the sample is
taken away. Use one hand holding
①
position,the other hand holding
②
position.

Once the sample is damaged, must take steps to avoid pollution.

If rising microscope’s height with other parts, must keep it in horizontal
position, avoid incline and sample slip.
Fig.1
Carrying Diagram
Fig.2
Replace Bulb
2. Before replacing the
lamp, first turn off
power switch at off
position O , and
unplug it in case of
electric shock and
burn.If microscope is
in use or after use,
the bulb and lamp
house must be
cooled off completely before proceeding, please see Fig.2 ,Loosening screw and
replace bad bulb with required bulb. The power supply must be cut off before bulb
replacement.
3.
Microscope must be placed on stable and horizontal table.
4. Only u
se our power line, wrong power line can’t guarantee instrument safety and
performance.
5.
The microscope ground terminal must be tightly connected with plug ground
terminal.
6.
If unexpected situation happens ,please pull the plug out.
7. Disassembly only by the professionals. The microscope has been adjusted before
shipping, Unprofessional-person should not disassemble and remove any other
parts.
If you have any questions, please contact with manufacturer or local distributor.
8. Wide voltage input 100
～
240V,47
～
63Hz, if not in this range, it may cause damage
for equipment.