User Manual – eSX
OptiPro Systems, LLC.
Page 35 of 111
Last Modified: 8/27/2014
7.4
Automatic Mode, for Jobs and External Programs
The Automatic Mode screen displays during the program cycle, and will appear after tapping [RUN] from
the Job screen or can be accessed from the G-Series Submenu (Section 7.2).
The Automatic Mode screen (Figure 7-4) will display axis position, spindle speed and load information,
cycle time, and (optionally) program lines. The Progress bar indicates the percent of the program that is
complete. Active M and G codes are shown in the lower right corner for reference.
Overriding the feed rate will impact the total processing time, however, the Estimated Time is based on
100% Feed Rate and will not update to reflect the override.
Figure 7-4: Automatic Mode
7.4.1
Motion Stop (for non-emergencies)
In Emergencies: Press the
E-STOP
button
on the Jog Panel (Figure 5-9) in any situation in which the
operator feels it is warranted to immediately halt axis motion. See Section 6.3 for more information
regarding E-Stop.
To pause the cycle in a non-emergency situation, press the
MOTION STOP
button (Figure 5-6). Note that
only axis motion will stop; spindle motion will continue as will coolant, vacuum, and any other utilities.
To continue select one of the follow options:
a.
Press
E-STOP
on the Jog Panel (Figure 5-9) to stop all axes, spindles, and coolant flow; work
holding vacuum will remain active. See Section 6.3 for more information regarding E-Stop.
b.
Continue the cycle by pressing the
CYCLE START
button on the Jog Panel (Figure 5-6).
Axis Status Window
Spindle Load
Meters
Feed Rate and
Spindle Speeds
Cycle Time
Active M
and G Codes