Optimus UMX-TEL, Руководство по эксплуатации

Страница: 11 / 16

UMX-TEL version 4.3.000AS 11
UMX-TEL
(ASIA VERSION)
DTMF Telephone interface card
for UMX-03/0 audio matrix
If the zone entered is busy due to an announcement of higher priority, busy tones will be heard and the card will hang up. The
same will occur if the destination unit is a group and all the zones in the group are busy. If the group has free zones and busy
zones, the calling process continues.
7. Once the zone (or group) number has been entered, a long tone will be heard, indicating that the message can now be
broadcast. At the end of the message, hang up the telephone or press 1. By default, the system will hang up automatically
once the communication time defined when the card is configured has elapsed.
4.3. CONFIGURATION EXAMPLE AND SENDING AN ANNOUNCEMENT
We will define the following configuration:
1 2 3 2 0 2 2 2 0 2
Password 123
Answer
after 2 call
tones
Debug
mode OFF
Number
of zone or
group
digits
Hanging
up DTMF
“1” tone
detection:
120ms
Hanging
up tone
detection:
225ms
Noise gate:
Deactivated
Communication
time: 30 s.
CONFIGURATION OF THE CARD
1. Press the CONFIG. button on the rear panel of the card. The CONFIG. LED will start to blink quickly.
2. Dial the telephone number corresponding to the card. When the card answers, the CONFIG. LED will remain lit and THREE
DIFFERENT TONES will be heard.
3. Enter the ten digits (parameters) of the intended configuration (in this case 1 2 3 2 0 2 2 2 0 2).
4. THREE IDENTICAL TONES will be heard, confirming that programming has been completed correctly, and then the card hangs
up automatically.
5. Hang up the telephone. The CONFIG. LED blinks slowly, indicating that the system is now configured.
NB: The user has approximately 60 seconds to make the call and send the configuration parameters.
SENDING AN ANNOUNCEMENT
1. To broadcast an announcement, pick up the telephone and call the number corresponding to the card.
2. After 2 call tones the card answers and the CONFIG. LED stops blinking and remains lit.
3. After a series of consecutive identical tones, enter the three digits corresponding to the password (1, 2, 3) and then the two
digits of the zone or group to which it is wished to send the message.
4. A long tone will be heard. Speak after this tone. You have 30 seconds to broadcast the announcement.
5. To end the announcement, hang up the telephone or press “1”.