OPERATING INSTRUCTIONS:
SETTING UP
•
Carefully remove your fan from the box (please save the carton for off-season storage).
•
Make sure the unit is in the OFF position before plugging the unit into the outlet.
ASSEMBLY INSTRUCTIONS
(refer to the picture)
1)
Take out the fan body and foot plate from the
packing box;
2)
Lay down the base upwards, and insert the
foot plate into the base as picture shows
OPERATING
1)
Plug the power cord into any standard 120V
AC, 60HZ outlet. Please make sure the
Selector (Speed Control) is in the OFF
position.
A loose fit between the AC outlet
and plug may cause over heating of the plug.
Have a qualified electrician to replace the
old outlet if the power cord feels extremely
hot.
2)
3 Speed Rotary Switch:
Select the switch knob to the desired fan speed setting.
3)
Tilt and adjust the fan head to the desired angle of airflow.
CLEANING
During Season Care:
•
Before cleaning, be sure to turn off and unplug the unit.
•
Keep the fan clean. Carefully wipe the unit with a soft, damp cloth. Please be very cautious
near the motor.
•
DO NOT immerse the fan in water and never allow water to drip into the Motor Housing.
•
Never use gasoline, benzene or thinner. This will damage the surface of the unit.
•
After cleaning, be sure to completely dry the unit with a cloth or towel.
After Season Care:
•
Your fan can be stored in the off-season.
•
Before putting the fan in storage, clean it thoroughly, cover it with a vinyl bag, and store it
in a cool and dry place. We recommend using the original (or appropriately sized) box.
MAINTENANCE INSTRUCTIONS:
A loose fit between the AC outlet and plug may cause over heating of the plug. If the plug
over heats, it might cut off the fuse inside the power cord plug.
If your fuse access cover is located on the side of the plug:
•
Grasp plug and remove from the receptacle or other outlet device. Do not yank the
cord to unplug.
•
Select a suitable tool such as a small flat screwdriver or travel scissors.
•
To open the fuse cover. Slide open fuse access cover on top of attachment plug
toward blades. (see fig.1)
•
Carefully remove the fuse by prying it out. (see fig.2)
•
Risk of fire can result by using wrong fuse rating. Replace fuse only with 2.5 Amp,
125 Volt rating.
•
To close the fuse access cover. Slide to close access cover on top of attachment
plug. (see fig.3)
Fig.1 Fig.2 Fig.3
If your fuse access cover is located on the face of the plug:
•
Grasp plug and remove from the receptacle or other outlet device. Do not yank the
cord to unplug.
•
Select a suitable tool such as a small flat
screwdriver or travel scissors.
•
To open the fuse cover. Press the tool
down, and then pry the protection door off
of the face of the plug. (see fig. #1)
•
Continue to remove protection door until
you can access the fuse below. (see fig.
#2)
•
Carefully remove the fuse by prying it out.
•
Risk of fire can result by using wrong fuse
rating. Replace fuse only with 2.5 Amp, 125 Volt rating.
•
To close the Close fuse cover. Push the protection door back onto the face of the
plug and press it securely in place.