Operation
Version 1.0.1 dated 2017-11-16
Page 36
Translation of the original instructions
TX6222
GB
T
X
6222
_GB
_4.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
Position the control handles as shown on the chart.
Example:
Feed 0.1mm / spindle revolution
=
1/1 - B - 1 - M -
Set the feed lever on headstock to
1/1
Set the selection lever
on swivel gear drive to
B
.
Set the selection lever on swivel gear drive to
1
.
Set the both selection lever
and
on swivel gear drive to
M
.
Set the selection lever
to
.
4.9.2
Cross feed selection
Select the suitable feed for the work to be carried out.
Position the control handles as shown on the chart.
Example:
Feed 0.15mm / spindle revolution
(in the chart 0.3 / 2 = 0.15)
=
1/1 - C - / - M -
Set the feed lever on headstock to
1/1
Set the selection lever
on swivel gear drive to C .
Set the selection lever on swivel gear drive to
7
.
Set the both selection lever
and
on swivel gear drive to
M
.
Set the selection lever
to
.
4.9.3
Thread selection
Set the selector lever for the thread to be cut according to the symbol.
M
= Metric
W
= Inches (Whitworth)
MOD
= Module
DP
= Diametral Pitch
Verify the position of the change gear bar gears corresponding to the chart.
Example:
Metric thread with a pitch of 5mm
=
METRIC - 4/1 - B - 4 - M
Use gear set
METRIC
for metric threads on the change gear bar.
Set the feed lever on headstock to
4/1
Set the selection lever
on swivel gear drive to
B
.
Set the selection lever on swivel gear drive to
4
.
Set the selection lever
and
on swivel gear drive to
M
.
INFORMATION
The bed slide is moved towards the lathe chuck or tailstock using the selection lever for the
feed on the headstock. Adjust as required.
ATTENTION!
Only adjust gear settings when the lathe is being completely stopped.
4.10
Spindle seat Camlock DIN ISO 702-2
CAUTION!
Regularly check the closed status of the clamp bolt.
D
E
F
G
D
E
F
G
D
E
F
G
