OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.3.0 dated 2016-12-16
Page 6
Original operating instructions
MF2 Vario
GB
1.3
Intended use
WARNING!
In the event of improper use, the milling-machine
will endanger personnel,
the milling-machine and other material property of the operating company will be
endangered,
the correct function of the milling-machine may be affected.
The milling-machine is designed and manufactured to be used for milling and drilling cold met-
als or other non-flammable materials or materials that do not constitute a health hazard by
using commercial milling and drilling tools.
Using this machine it is possible to perform dry processing as well as processing by using cool-
ing lubricants.
The limit values of the balances of the tools need to be observed.
The milling-machine must only be installed and operated in a dry and well-ventilated place.
The milling-machine is designed and manufactured to be used in a non-explosive environment.
Intended use
If the milling-machine is used in any way other than described above, modified without the
approval of the company Optimum Maschinen Germany GmbH then the milling-machine is
being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that
the maximum values for the milling-machine are complied with,
the operating manual is observed,
the inspection and maintenance instructions are observed.
WARNING!
Heaviest injuries through improper use.
Activation forbidden!
Read the operating
instructions before
commissioning!
Disconnect the mains plug!
Use protective glasses!
Use protective gloves!
Use protective boots!
Use protective suit!
Use ear protection!
Only switch in standstill!
Protect the environment!
Contact address
