23
common arrhythmias such as atrial or ventricular premature
beats or atrial fibrillation,
arterial sclerosis, poor perfusion, diabetes, preeclampsia, renal
diseases.
23. The patient is an intended operator.
24. Attention that changes or modification not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
25. Swallowing batteries and/or battery fluid can be extremely
dangerous. Keep the batteries and the unit out of the reach of
children and disabled persons.
26. If you are allergic to plastic/rubber, please don’t use this device.
SETUP AND OPERATING PROCEDURES
1. BATTERY LOADING
a. Open battery cover at the back of the monitor.
b. Load four “AAA” size batteries. Please pay attention to polarity.
c. Close the battery cover.
When LCD shows battery symbol
, replace all batteries with
new ones.
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month
or more to avoid relevant damage of battery leakage.
Avoid the battery fluid to get in your eyes. If it should get in
your eyes, immediately rinse with plenty of clean water and con-
tact a physician.
The negative terminal of the battery needs to be compres-
sed into the battery compartment properly after horizontal
compression of the negative electrode. The battery is in contact
with the spring.
Make sure the battery cover is intact and not damaged befo-
re installing the battery.
The monitor, the batteries and the cuff, must be disposed of
according to local regulations at the end of their usage.
2. CLOCK AND DATE ADJUSTMENT
a. Once you insert the battery, the Blood Pressure Monitor will
enter Clock and Date Adjustment Mode.
b. If the time of the device is already set and need to be chan-
ged, adjustment can be reached by pressing both the “START”
and “MEM” button for 2 seconds in Standby Mode.
c. In Clock and Date Adjustment Mode, the time format will blink
at first. Press the button “MEM” can change time format. Press
the button “START” repeatedly, the year, month, day, hour and
minute will blink in turn. While the number is blinking, press
the button “MEM” to increase the number. Keep on pressing
the button “MEM”, the number will increase fast.
d. You can turn off the monitor by pressing “START” button when
the minute is blinking, then the time and date is confirmed.
